You are here: Home > Installation Info

DASH INSTALLATION

Our industry exclusive Dash Kit installation system is the easiest, fastest, safest and most accurate in the industry. We exclusively back our Dash Trim Kits with 3M 5849 Primer-less Acrylic Foam Adhesive. This premium Factory Approved product does not require the tedious and time consuming step of applying promoter to each part prior to installation.

With no promoter required, there is no risk of damaging your factory parts by accidentally applying promoter to areas not covered by the dash kit. And, there is no risk of spilling hazardous promoter on your hands.

All pieces in our Wood Dash Kits are packaged on single layers of adhesive liner (each the size of the box), as opposed to liner backing on every single part. This provides a true lift & stick installation without the need to spend time removing the liner off each individual part.

Finally, because promoter is actually built-in to the premium 3M adhesive and takes 72 hours to fully cure, you can remove and re-position parts until the fit is perfect (see installation instructions for details). However, when promoter is applied to a part, it is extremely difficult to remove and re-position without damaging the dash part or heavily contaminating the adhesive.

_______________________________________________




Step 1 CLEAN THE SURFACE

Use the alcohol pads included in your kit to wipe all surfaces clean. In many cases, you may need to repeat this step more than once.



Step 2 LIFT PART FROM BOX

Identify the location on the dash where each piece in your kit is to be applied. In preparation for the installation of each piece, simply lift it off the packing board.



Step 3 INSTALL PART

Starting with any of the larger pieces and beginning from any edge,
apply the piece onto the dash.

Do not press firmly into place until you are comfortable with the parts position. If the piece is not positioned properly, simply lift it up and re-install
to achieve the desired fit.